Summit RG200W Manual Do Proprietário

Phillips screwdriver

Flat-blade screwdriver

Pencil and ruler

Pipe wrenches (2)

(one for backup)

Open-end or

adjustable wrench

Level

Drill, awl or nail

Installation

Instructions

Range

If you have questions, call 1.800.932.4267

or visit our Website at: www.summitappliance.com

• This product must be installed by a licensed plumber or

gas fitter.

• When using ball type gas shut-off valves, they shall be

the T-handle type.

• A flexible gas connector, when used, must not exceed 3 feet

In the Commonwealth of Massachusetts

FOR YOUR SAFETY

Mobile Home - Additional Installation Requirements
The installation of this range must conform to the

Manufactured Home Construction and Safety Standard,

Title 24 CFR, Part 3280 (formerly the Federal Standard for

Mobile Home Construction, use the Standard for

Manufactured Home Installations, ANSI A225, 1/NFPA 501A

or with local codes.

IMPORTANT —

Save these instructions for local

electrical inspector’s use.

IMPORTANT —

Observe all governing codes and

ordinances.
•

Note to Installer -

Leave these instructions with the

appliance after installation is completed.
•

Note to Consumer -

Keep this Owner’s Manual and

Installation Instructions for future reference.
•

Note -

This appliance must be properly grounded.

•

Servicer -

The electrical diagram is in an envelope

attached to the back of the range.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered

under the Warranty.

As with any appliance using gas and generating heat,

there are certain safety precautions you should follow. You

will find these precautions in the Important Safety

Information section in the front of this manual. Read them

carefully.

BEFORE YOU BEGIN

Read these instructions completely and carefully.
Installation of this range must conform with local codes, or

in the absence of local codes, with the National Fuel Gas

Code, ANSI Z223.1/NFPA.54, latest edition. In Canada,

installation must conform with the current Natural Gas

Installation Code, CAN/CGA-B149.1 or the current Propane

Installation Code, CAN/CGA-B149.2, and with local codes

where applicable. This range has been design-certified by

CSA International according to ANSI Z21.1, latest edition

and Canadian Gas Association according to CAN/CGA 1.1

latest edition.

Mobile home installations require:
• When this range is installed in a mobile home, it must be

secured to the floor during transit. Any method of securing

the range is adequate as long as it conforms to the

standards listed above.

Do not store or use combustible materials, gasoline or

other flammable vapors and liquids in the vicinity of this

or any other appliance.

1. Open windows.
2. Don’t touch electrical switches.
3. Extinguish any open flame.
4. Immediately call your gas supplier.

If you smell gas:

TOOLS YOU WILL NEED

MATERIALS YOU MAY NEED

*Teflon: Registered trademark of DuPont

• Gas line shut-off valve
• Pipe joint sealant or UL-approved pipe thread tape

with Teflon* that resists action of natural and LP gases

• Flexible metal appliance connector (1/2" I.D.)

A 5-foot length is recommended for ease of installation

but other lengths are acceptable. Never use an old

connector when installing a new range.

• Flare union adapter for connection to gas supply line

(3/4" or 1/2" NPT x 1/2" I.D.)

• Flare union adapter for connection to pressure

regulator on range (1/2" NPT x 1/2" I.D.)

• Liquid leak detector or soapy water.
• Lag bolt or 1/2" O.D. sleeve anchor (for concrete floors

only).