Frigidaire FHWC3640MS Manual Do Proprietário

 

Lift the range hood up under cabinet and determine 

  final location by centering beneath cabinet. Mark on 

  the underside of cabinet the location of the 4 keyhole  

  mounting slots on the range hood (See slots  

  dimensions on page 6). Set range hood aside on a  

  covered surface. 

 

 

 

 

 

 

 

 

Use ¹⁄

8

” (3 mm) drill bit and drill 4 pilot holes as shown. 

NOTE: Make the drill holes on the thin area of the slot.  

 

 

 

Install the 4 - .45 cm x 1.3 cm mounting screws in 

  pilot holes. Leave about ¼” (6.4 mm) space between   

  screw heads and cabinet to slide range hood into place. 

 

 

 

For direct wire installations, run the home power 

  supply cable according to the National Electric Code 

  or CSA standards and local codes and ordinances. 

  There must be enough wiring from the fused disconnect  

  (or circuit breaker) box to make the connection in the 

  hood electrical terminal box. 

 

  

 

Remove the screw from the  

  terminal box cover.  

  Remove terminal box cover  

  and set aside. 

 

 

¹⁄4”

(6.4 mm)

A

A. Drill pilot hole

Remove the power supply knockout from the top 

  or rear of the vent hood (depending on the incoming 

  location of your home power supply cable) and  

  install a UL listed or CSA approved ½” strain relief. 

 

 

 

 

 

 

 

 

 

Using 2 or more people, lift the hood into final position. 

  Feed enough electrical wire through the ½” UL listed  

  or CSA approved strain relief to make connections in  

  the terminal box. Tighten the strain relief screws.

Position the range hood so that the large end of 

  the keyhole slots are over the mounting screws. 

  Then push the hood toward the wall so that the screws  

  are in the neck of the slots. Tighten the mounting screws,  

  making sure the screws are in the narrow neck of slots.

For installations which are recirculating the air exhaust, 

the recirculation vent cover must be removed.  

Remove the recirculating  

vent cover by removing  

the 2 mounting screws  

with a phillips screwdriver.   

 

NOTE: For installations  

which are venting out  

the roof or wall, the  

must remain in place.    

Do not remove as unit  

will not perform properly.

Part being removed

A

A. Power supply  
     knockout

A. Terminal box cover
B. Screw

A

A. Keyhole slot

A