Frigidaire FHWC3025MB Manual Do Proprietário

Remove the power supply knockout from the top 

  or rear of the vent hood (depending on the incoming 

  location of your home power supply cable) and  

  install a UL listed or CSA approved ½” strain relief. 

 

 

 

 

 

 

 

 

 

Using 2 or more people, lift the hood into final position. 

  Feed enough electrical wire through the ½” UL listed  

  or CSA approved strain relief to make connections in  

 the terminal box. Tighten the strain relief screws.

Position the range hood so that the large end of 

  the keyhole slots are over the mounting screws. 

  Then push the hood toward the wall so that the screws  

  are in the neck of the slots. Tighten the mounting screws,  

  making sure the screws are in the narrow neck of slots.

For installations which are recirculating the air exhaust,

the recirculation vent cover must be removed.  

Remove the recirculating  

vent cover by removing  

the 2 mounting screws  

with a phillips screwdriver.   

 

NOTE: For installations  

which are venting out  

the roof or wall, the  

recirculating vent cover  

must remain in place.    

Do not remove as unit  

will not perform properly.

To complete the installation, go to “Make Electrical  

Connection” section on page 11.

The range hood is designed to remove smoke, cooking 

vapors and odors from the cooktop area. For best results, 

start the hood before cooking and allow it to operate 

several minutes after the cooking is complete to clear all 

smoke and odors from the kitchen.

The hood controls are located on the top of the range hood.

Push the light switch to the right to turn the light On. 

Push the light switch to the left to the turn the light Off. 

Push the fan switch to the left for Low speed. Push the 

fan switch to the right for High speed. Push the fan 

switch to the middle for Off. 

A. Incandescent light housing and cover

B. Charcoal filter retainer

C. Grease filter

A

C

B

A. On/Off light switch

B. Fan speed switch

A

B

w

o

L

n

O

High

Part being removed

A

A. Power supply  
     knockout