Perlick 15" Signature Series Clear Ice Maker - Solid Stainless Door - Right Hinge Guia De Utilização

8

To prevent damage to the freezer mechanism, do not operate this Ice Maker
when the water supply is OFF, or if the pressure is below 10 PSIG (0.7 bar),
the recommended water pressure.  Stop the Ice Maker until proper water
pressure is resumed.

* Attach the brass fitting included in the accessory bag as shown in Fig. 5.  The brass fitting

size is a 1/2" FPT and must be connected only to a potable water supply.

* A water supply line shut-off valve and drain valve must be installed.

* Water supply pressure should be a minimum of 10 PSIG (0.7 bar) and a maximum of 113

PSIG (7.5 bar).  If the pressure exceeds 113 PSIG (7.5 bar), use a pressure reducing
valve.

* Drain outlet hose is 5/8" (16mm) ID and internally connected with 2/3" (17mm) OD drain

outlet.

* For gravity drain installation, drain must be 1/4" fall per foot (2 cm fall per meter) on horizontal

runs to get good flow.

* Keep a more than 2 vertical inch
   (5 vertical cm) air gap between
   the drain pipe end and the sink.

* The drain pipe must be so laid as to prevent

a backflow into the Storage Bin.

* For condensate pump installation for exiting

drain, refer to condensate pump instruction
manual.

*  A plumbing permit and services of a licensed

plumber may be required in some areas.

* This Ice Maker should be installed in

accordance with applicable national, state
and local regulations.

Ice Maker

Shut-off Valve

Drain Valve

Water Supply Inlet
3/4" BSP Threads

Bin Drain Outlet
Hose 5/8" ID

1/4" fall per foot

To approved floor drain

Attach brass fitting to
Water Supply Inlet.
Fitting size is a 1/2" FPT