Honeywell XL 800 SERIES Manual Do Utilizador

Excel 800 

 

 3 

EN1B-0410GE51 

R0908A 

 
This equipment generates, uses, and can radiate radio 
frequency energy, and if not installed and used in accordance 
with the instructions manual, may cause interference to radio 
communications. It has been tested and found to comply with 
the limits for a Class A computing device pursuant to Subpart 
J of Part 15 of FCC Rules, which are designed to provide 
reasonable protection against such interference when 
operated in a commercial environment. Operation of this 
equipment in a residential area is likely to cause interference, 
in which case the user, at his own expense, will be required to 
take whatever measures may be required to correct the 
interference. Any unauthorized modification of this equipment 
may result in the revocation of the owner’s authority to 
continue its operation. 
 

The XL800 Series is designed to provide heating, ventilating 
and air-conditioning control. They can operate either 
standalone, or networked to Honeywell central workstations 
such as EBI. These controllers can also be used for smoke 
control system monitoring and control, for monitor and control 
of fire (UL864), and general purpose signaling (UL2017). In 
UL 2017 applications, the product can be used as a type NM 
(Non-Monitored) system. It is also approved for UL916 
(Energy Management Equipment.) 
The XL800 Series can be used for smoke control applications 
when used in conjunction with a UL listed fire alarm control 
panel (FACP) and UL listed fire fighters’ smoke control station 
(FSCS). 
 

1.  Unpack door and remove the XL800 from carton. Check 

equipment and report any damage to a Honeywell 
representative. 

2.  Verify cabinet is installed correctly.

 

3.  Securely mount the XL800 to a rigid structural surface 

using at least four sets of 1/4 in. (6 mm) mounting 
hardware (supplied locally). 

NOTE: 

Anchoring materials must be suitable for the 
mounting surface (wood, concrete, steel). 
Mounting must comply with all local codes. 

4.  Obtain correct number and type of sheet metal screws for 

subpanel. Installation of a full-size subpanel requires six 
no. 10 x ½-inch (13 mm) sheet metal screws (not 
supplied). Installation of a smaller subpanel requires four 
no. 10 x ½-inch (13 mm) sheet metal screws (not 
supplied). 

5.  Obtain 14505159-001 Tamper Switch per job 

requirements. Installation of Tamper Switch is optional. 

 

Mount controller subpanel in cabinet so all labeling is visible. 
Secure full-size subpanel in place with six no. 10 x ½-inch 
(13 mm) sheet metal screws (not supplied). Secure smaller 
subpanel with four no. 10 x ½-inch (13 mm) sheet metal 
screws (not supplied). 
NOTE: 

Subpanel must mount flat and should not bulge or 
recess anywhere. 

 

FULL-SIZE

CABINET

SIX NO. 10 x ½-INCH (13 mm)

SHEET METAL SCREWS