Sharp XL-MP15H Manual Do Utilizador

8

7

6

5

4

3

2

1

XL-MP15H AUS 01-16.fm

2009June11

The radio, compact disc and audio in mode can all be turned off
automatically.

To cancel the sleep operation:
To cancel the sleep operation without setting the unit to the stand-by
mode, proceed as follows.

Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up
to CD in the next morning.

The connection lead is not included. Purchase a commercially
available lead as shown below.

Note:
To prevent noise interference, place the unit away from the
television.

● Do not turn the volume on to full at switch on. Listen to music at

moderate levels. Excessive sound pressure from earphones and
headphones can cause hearing loss.

● Before  plugging in or unplugging the headphones, reduce the

volume.

● Be sure your headphones have a 3.5 mm (1/8") diameter plug

and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.

● Plugging in the headphones disconnects the speakers

automatically. Adjust the volume using the VOLUME control.

■ Sleep operation

Play back the desired sound source.

Press the SLEEP button repeatedly to select the time.
(Maximum: 90 minutes - Minimum: 10 minutes)

The unit will enter the power stand-by mode automatically after
the preset time has elapsed.

Press the SLEEP button once.

● The remaining sleep time is displayed for about 10 seconds.

● You can change the remaining sleep time whilst it is

displayed by pressing the SLEEP button (step 2).

Press the SLEEP button repeatedly to select “SLEEP 00”.

■ To use timer and sleep operation together

Set the sleep time (see “Sleep Operation”).

Whilst the sleep timer is set, set the timer playback (steps 2 - 14,
page 13).

Timer playback start time

Sleep operation will 
automatically stop 

Timer playback setting

Sleep timer setting

End time

Desired time

90 minutes

■ Listening to the playback sounds of 

Use a connection lead to connect the portable audio player etc.
to the AUDIO IN socket.

Press the ON/STAND-BY button to turn the power on.

Press the AUDIO IN button.

Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
If volume level is too low, increase the volume of the connected
device.

■ Headphones