Hitachi L200 Manual Do Utilizador

L200 Inverter

In

v

e

rt

er Mounting

and Installation

The terminal screw dimensions for all L200 inverters are listed in table below. This 
information is useful in sizing spade lug or ring lug connectors for wire terminations.

CAUTION: Fasten the screws with the specified fastening torque in the table below. 
Check for any loosening of screws. Otherwise, there is the danger of fire.

When connecting wiring, use the tightening torque listed in the following table to safely 
attach wiring to the connectors.

Step 6: In this step, you will connect wiring to the 
input of the inverter. First, you must determine 
whether the inverter model you have requires 
three-phase power only, or if it can accept either 
single-phase or three-phase power. All models 
have the same power connector terminals [R/L1], 
[S/L2], and [T/L3]. So, you must refer to the 
specifications label (on the side of the inverter) 
for the acceptable power source types! For 
inverters that can accept single-phase power 
and are connected that way, terminal [S/L2] 
will remain unconnected.
The wiring example to the right shows an L200 
inverter wired for 3-phase input. Note the use of 
ring lug connectors for a secure connection.

Power Terminals

12

M3.5

7.1

M4

9

M5

13

Control Signal

16

M2

—

M2

—

M2

—

Alarm  Signal

3

M3

—

M3

—

M3

—

Ground Terminals

2

M4

—

M4

—

M5

—

M2

0.2 N•m (max. 0.25 N•m) M3.5

0.8 N•m (max. 0.9 N•m)

M5

2.0 N•m (max. 2.2 N•m)

M3

0.5 N•m (max. 0.6 N•m)

M4

1.2 N•m (max. 1.3 N•m)

—

—