Hitachi L200 Manual Do Utilizador

L200 Inverter

In

v

e

rt

er Mounting

and Installation

Please take a moment to familiarize yourself with the keypad layout shown in the figure 
below. The display is used in programming the inverter’s parameters, as well as monitor-
ing specific parameter values during operation.

• Run/Stop LED - ON when the inverter output is ON and the motor is developing 

torque (Run Mode), and OFF when the inverter output is OFF (Stop Mode).

• Program/Monitor LED - This LED is ON when the inverter is ready for parameter 

editing (Program Mode). It is OFF when the parameter display is monitoring data 
(Monitor Mode).

• Run Key Enable LED - is ON when the inverter is ready to respond to the Run key, 

OFF when the Run key is disabled.

• Run Key - Press this key to run the motor (the Run Enable LED must be ON first). 

Parameter F004, Keypad Run Key Routing, determines whether the Run key generates 
a Run FWD or Run REV command.

• Stop/Reset Key - Press this key to stop the motor when it is running (uses the 

programmed deceleration rate). This key will also reset an alarm that has tripped.

• Potentiometer - Allows an operator to directly set the motor speed when the potenti-

ometer is enabled for output frequency control.

• Potentiometer Enable LED - ON when the potentiometer is enabled for value entry.

• Parameter Display - A 4-digit, 7-segment display for parameters and function codes.

• Display Units, Hertz/Amperes - One of these LEDs will be ON to indicate the units 

associated with the parameter display.

• Power LED - This LED is ON when the power input to the inverter is ON.

• Alarm LED - ON when an inverter trip is active (alarm relay contacts will be closed).

• Function Key - This key is used to navigate through the lists of parameters and 

functions for setting and monitoring parameter values.

• Up/Down ( ,  

) Keys - Use these keys alternately to move up or down the lists of 

parameter and functions shown in the display, and increment/decrement values.

• Store ( 

 ) Key - When the unit is in Program Mode and you have edited a parameter 

value, press the Store key to write the new value to the EEPROM.

1

2

5 0.0

RESET

FUNC.

STR

POWER

ALARM

RUN

A

Hz

PRG

Function key

Up/Down keys

Store key

Parameter Display

Run/Stop LED

Program/Monitor LED

Run Key Enable LED

Run Key

Stop/Reset Key

Power LED

Display Units (Hertz / Amperes) LEDs

Potentiometer Enable LED

Potentiometer

Alarm LED

Serial port

1

2