Kenwood NX-210 Manual Do Utilizador

Scan monitors for signals on the transceiver channels.  While 

scanning, the transceiver checks for a signal on each channel 

and only stops if a signal is present.

To begin scanning, press the key programmed as Scan.

•  The   icon appears on the display.
•  When a signal is detected on a channel, Scan pauses at that 

channel.  The transceiver will remain on the busy channel until the 

signal is no longer present, at which time Scan resumes.

To stop scanning, press the Scan key again.

 To use Scan, there must be at least 2 channels in the scan 

sequence.

During scan, you can temporarily remove specific channels 

from the scanning sequence by selecting them and pressing 

the key programmed as Scan Delete/Add.

•  The channel is no longer scanned. However, when scanning is 

ended and restarted, the channels are reset and deleted channels 

will again be in the scanning sequence.

 To use Priority Scan, a Priority channel must be programmed.

When using a single Priority channel, the transceiver will 

automatically change to the Priority channel when a call is 

received on that channel, even if a call is being received on a 

normal channel.

When using dual Priority channels, Priority channel  is given 

precedence over Priority channel 2.  So, if a call is received on 

Priority channel  while a call is already on Priority channel 2, 

the transceiver will change to Priority channel .