Vertex Standard FT-950 Manual Do Utilizador
FT-950
Operating Manual
Vertex Standard Co., Ltd.
26
56. [CLEAR] Switch
Pressing this button clears out any frequency offset you have programmed into the
Clarifier register (thereby setting the offset to “Zero”).
57. [(VFO-B)RX] Indicator/Switch
This is the button that switches the receiving frequency to the VFO-B, the green LED
imbedded within the button will light up. Pressing this button again will return the
receiving frequency to the VFO-A, and the imbedded green LED will turn off.
58. [(VFO-B)TX] Indicator/Switch
This is the button that turns the VFO-B transmitter “On” and “Off”. When this button
is pressed to transfer transmitter control to the VFO-B frequency and mode, the red
LED imbedded within the button will light up. Pressing this button again will transfer
frequency/mode control back to the VFO-A side, and the red LED imbedded within this
button will turn off.
59. [BAND] Switch
Pressing this button allows you to select the operating band (Amateur bands) using the
[CLAR/VFO-B] knob.
60. [GRP] Switch
Pressing this button allows you to select the memory group using the [CLAR/VFO-B]
knob.
61. [MHz] Switch
Pressing this button allows you to tune the VFO frequency down or up in 1 MHz
increments, using the [CLAR/VFO-B] knob.
62. [MCH] Switch
Pressing this button allows you to select the memory channel using the [CLAR/VFO-B]
knob.
63. [CLAR/VFO-B] Knob
This knob usually tunes the Clarifier offset frequency up to ±9.99 kHz, otherwise, this
knob is used to adjust the status of the functions depending on the five buttons located
around this knob.
Pressing this button clears out any frequency offset you have programmed into the
Clarifier register (thereby setting the offset to “Zero”).
57. [(VFO-B)RX] Indicator/Switch
This is the button that switches the receiving frequency to the VFO-B, the green LED
imbedded within the button will light up. Pressing this button again will return the
receiving frequency to the VFO-A, and the imbedded green LED will turn off.
58. [(VFO-B)TX] Indicator/Switch
This is the button that turns the VFO-B transmitter “On” and “Off”. When this button
is pressed to transfer transmitter control to the VFO-B frequency and mode, the red
LED imbedded within the button will light up. Pressing this button again will transfer
frequency/mode control back to the VFO-A side, and the red LED imbedded within this
button will turn off.
59. [BAND] Switch
Pressing this button allows you to select the operating band (Amateur bands) using the
[CLAR/VFO-B] knob.
60. [GRP] Switch
Pressing this button allows you to select the memory group using the [CLAR/VFO-B]
knob.
61. [MHz] Switch
Pressing this button allows you to tune the VFO frequency down or up in 1 MHz
increments, using the [CLAR/VFO-B] knob.
62. [MCH] Switch
Pressing this button allows you to select the memory channel using the [CLAR/VFO-B]
knob.
63. [CLAR/VFO-B] Knob
This knob usually tunes the Clarifier offset frequency up to ±9.99 kHz, otherwise, this
knob is used to adjust the status of the functions depending on the five buttons located
around this knob.