Whirlpool RF354BXG Manual Do Utilizador
8
Coil Elements and
Burner Bowls
(on some models)
Coil elements should be level for optimal cooking results. Burner
bowls, when clean, reflect heat back to the cookware. They also
help catch spills.
bowls, when clean, reflect heat back to the cookware. They also
help catch spills.
Cookware should not extend more than 1 in. (2.5 cm) over the
coil element. If cookware is uneven or too large, it can produce
excess heat causing the burner bowl to change color. For more
information, see the “Cleaning” section.
coil element. If cookware is uneven or too large, it can produce
excess heat causing the burner bowl to change color. For more
information, see the “Cleaning” section.
Before removing or replacing coil elements and burner bowls,
make sure they are cool and the control knobs are off.
make sure they are cool and the control knobs are off.
To Remove:
1.
Push in the edge of coil element toward the receptacle. Then
lift it just enough to clear the burner bowl.
lift it just enough to clear the burner bowl.
2.
Pull the coil element straight away from the receptacle.
3.
Lift out the burner bowl.
To Replace:
1.
Line up openings in the burner bowl with the coil element
receptacle.
receptacle.
2.
Holding the coil element as level as possible, carefully push
coil element terminal into the receptacle.
coil element terminal into the receptacle.
3.
When the terminal is pushed into the receptacle as far as it
will go, push down the edge of the coil element opposite the
receptacle.
will go, push down the edge of the coil element opposite the
receptacle.
Lift-up Cooktop
(on some models)
The lift-up cooktop provides easy access underneath it for
cleaning. Be careful not to drop it because damage could occur
to the finish and the cooktop frame. For more information, see
the “Cleaning” section.
cleaning. Be careful not to drop it because damage could occur
to the finish and the cooktop frame. For more information, see
the “Cleaning” section.
To Lift:
1.
Lift the front of the cooktop at both front corners until the
support rods lock into place.
support rods lock into place.
To Replace:
1.
Lift the cooktop from both sides while pressing the support
rods back to unlock them.
rods back to unlock them.
2.
Slowly lower the cooktop into place.
Home Canning
When canning for long periods, alternate the use of surface
cooking areas, elements or surface burners between batches.
This allows time for the surrounding areas to cool.
cooking areas, elements or surface burners between batches.
This allows time for the surrounding areas to cool.
■
Center the canner on the grate or largest surface cooking
area or element. Canners should not extend more than 1 in.
(2.5 cm) outside the cooking area.
area or element. Canners should not extend more than 1 in.
(2.5 cm) outside the cooking area.
■
Do not place canner on two surface cooking areas, elements
or surface burners at the same time.
or surface burners at the same time.
■
On ceramic glass models, only use flat-bottomed canners.
■
On coil element models, the installation of a Canning Unit Kit
is recommended. If not installed, the life of the coil element
will be shortened. See “Assistance or Service” for ordering
instructions.
is recommended. If not installed, the life of the coil element
will be shortened. See “Assistance or Service” for ordering
instructions.
■
For more information, contact your local U.S. Government
Agricultural Department Extension Office. In Canada, contact
Agriculture Canada. Companies who manufacture home
canning products can also offer assistance.
Agricultural Department Extension Office. In Canada, contact
Agriculture Canada. Companies who manufacture home
canning products can also offer assistance.