GE JBP27GR Manual Do Utilizador

Drip Pans

Surface

Unit

Pan

the drip pans for cleaning. the surface units

removed first. Lift the surface unit about one

inch

drip pan and pull it out. Make sure the

surface units

completely cool

touching

them.

the drip pans with soap and water, plastic

or in the dishwasher. DO NOT CLEAN

IN SELF-CLEANING OVEN; pans will discolor.
Wipe

cooking unnoticed spatter

not

burn

next time you cook.

Do not lift the surface unit more than one inch. If
you do, it may not lie flat on the drip pan when you
plug it back in.

Repeated lifting of the surface unit more than one
inch above the drip pan can permanently damage
the receptacle.

To replace a surface unit:

●

Replace the drip pan into the recess in the cooktop.

Make sure opening in the pan lines up with
the receptacle.

●

Insert the terminals of the surface unit through the

opening in the drip pan and into the receptacle.

●

Guide the surface unit into place so it rests evenly.

Do not cover the drip pans with aluminum foil. Using
aluminum foil so close to the receptacle could cause
shock, fire or damage to the range.

Cooktop Surface Lamp

(on some models)

When changing a cooktop lamp, do not touch the

To replace:

metal at the ends of the lamp.

●

Place fingers on the top

is easily replaced with a fluorescent

each end of the lamp.

near

the

wattage._

changing the lamp,

●

Press the lamp into the slots

the

or disconnect the power at the

until it snaps into place.

fuse or circuit breaker panel.

●

Move lamp cover down and

remove:

snap into place.

●

Lift the

cover by pulling the bottom edge toward

then up.

fingers

top near each end of the lamp.

the

top

the lamp gently toward the front of the

and

pull the-lamp from the socket,

sure it does not hit the lamp cover.

Oven Vent

The oven is

through

opening under the right

rear surface unit. Never cover the opening with

aluminum

foil or any other material. This would

prevent the oven vent from working properly.

Vent

(continued next