GE JBP27GR Manual Do Utilizador

Página de 32
Metal Parts
Glass Surfaces
Do not use 
 wool, abrasives,
ammonia or commercial oven cleaners.
 
 
 surfaces; wash, rinse 
   
   .
 then dry with a soft cloth.
To clean the outside glass finish, use
a glass cleaner. Rinse and polish
with a dry cloth. Do not allow the
water or cleaner to run down inside
openings in the glass while cleaning.
 Oven Door
The oven door is removable
but it is heavy. You may need
 removing and replacing
the door.
 
 
 the door, open it a
 inches to the special “stop”
position that will hold the door
 
 
 on each side
    
 door straight up and off the hinges.
 Be careful not to place hands between the
 hinge and the oven frame as the spring hinge
 snap 
back and pinch your fingers.
To replace the door, make sure the hinges are in the
 position. Position the slots in the bottom of the
 
 over the hinges. Then lower the door
● 
Do not rub or clean the
door gasket–the
fiberglass material
of the gasket has
an extremely low
resistance to abrasion.
An intact and 
fitting oven door
gasket is essential for 
Inside
Gasket
Outside
energy-efficient oven
Gasket
Gasket
operation and good
baking results. If you notice the gasket becoming
worn, frayed or damaged in any way or if it has
become displaced on the door, you should have
it replaced.
Outside of door:
 and 
 over both hinges at the same time.
 
 THE DOOR:
( 1)0 
 immerse door 
in water.)
Inside 
of door:
 Because 
the 
area inside the gasket is cleaned during
the self clean cycle, you do not need to clean this by
hand. Any soap left on the liner causes additional
stains when 
 oven 
 heated.
● 
 
 outside the gasket can be cleaned with
 pad.
Use soap and water to thoroughly clean the top, sides
and front of the oven door. Rinse well. You may also
use a glass cleaner to clean the glass on the outside
of the door.
Spillage of marinades, fruit juices, tomato sauces and
basting materials containing acids may cause
discoloration and should be wiped up immediately.
When surface is cool, clean and rinse.
Do not use oven cleaners, cleansing powders or
harsh abrasives on the outside of the door.
Oven Lamp Replacement 
(on 
some models)
 Before replacing your
The oven lamp (bulb) is covered with
DO NOT REMOVE ANY
 lamp bulb, disconnect the
a removable glass cover which is
SCREWS TO REMOVE COVER.
electric power for your range at
held in place with a wire. Remove
the main fuse or circuit breaker
● 
Replace bulb with 40-watt home
the oven door, if desired, to reach the
appliance bulb.
panel or pull the plug.
cover easily.
To replace cover:
Be 
 to let the lamp cover and bulb
To remove:
//
cool completely before removing or
 Hold your hand
● 
Place it into the groove of the lamp
replacing them. 
 in 
 
 
 become warm enough to
under the cover
receptacle. Pull the wire forward to
the center of cover until it snaps in
   
 with   moist cloth
so it doesn’t fall
place. When in place, the wire
when released.
or 
 When cleaning, avoid
holds the cover firmly. Be certain
With fingers of 
 same hand,
 
 
 with cleaning
firmly push back 
 wire until it
the wire is in the depression in the
 i   
 lamp cover is removed.
center of the cover.
clears the cover. Lift off the cover.
 Connect electric power to the range.
● 
Do not touch hot bulb with a
wet cloth.
25