Marvel 6GARMP Manual Do Utilizador

The proper location will ensure peak performance of your ap-

pliance.  We recommend a location where the unit will be out 

of direct sunlight and away from heat sources.  To assure your 

product performs to specifications the recommended installation 

location temperature range is from 65 to 80°F (18 to 27°C) for 

indoor built in units, 65 to 90°F (18 to 32°C) for indoor freestand-

ing units.

Ventilation is required from the bottom front section of the unit.  

Keep this area open and clear of any obstructions.  Adjacent 

cabinets and counter top can be installed around the unit as long 

as the grille and door access remain unobstructed.   

4

Leveling Legs

Front Toe Grille, 

keep this area 

open.

Do not obstruct the front grille. The openings within the front 

grille allow air to flow through the condenser heat exchanger. 

Restrictions to this air flow will result in increased energy usage 

and loss of cooling capacity. For this reason it is important this 

area to not be obstructed and the grille openings kept clean. 

AGA MARVEL does not recommend the use of a custom made 

grille as air flow may be restricted because of inadequate open-

ings. (See Figure 2).

Adjustable legs at the front and rear corners of the unit should 

be set so the unit is firmly positioned on the floor and level 

from side to side and front to back. The overall height of your 

Marvel refrigerator may be adjusted from 33-7/8” (86.1cm) with 

the leveling legs turned in, and up to 34-3/4” (88.3cm) with the 

leveling legs extended.

To adjust the leveling legs, place the refrigerator on a solid 

surface and protect the floor beneath the legs to avoid scratch-

ing the floor. With the assistance of another person, lean the 

refrigerator back to access the front leveling legs. Raise or lower 

the legs to the required dimension by turning the legs. Repeat 

this process for the rear by tilting the refrigerator forward using 

caution. On a level surface check the refrigerator for levelness 

and adjust accordingly.

The front grille (toe grille) screws may be loosened and the grille 

adjusted to the desired height. When adjustment is complete 

tighten the two toe grille screws. (See Figure 4).

Rear leveling legs

Figure 3

Figure 2