Marvel 6GARMP Manual Do Utilizador

6

Figure 6

Control

Assembly

Plug the refrigerator power cord into a wall outlet. Your refrig-

erator will begin cooling a few seconds after power is applied.

If your refrigerator does not start, check that the refrigerator is 

turned on and the setpoint is cold enough.

If the refrigerator is on, the refrigerator temperature will be 

shown on the display. To turn the refrigerator off, press and hold 

the “ON/OFF” button for three (3) seconds. “OFF” will appear on 

the display. 

If the refrigerator is off. “OFF” will be shown on the display. To 

turn the refrigerator on, press and hold the “ON/OFF” button for 

three (3) seconds. The refrigerator temperature will be shown on 

the display.

To set the refrigerator temperature, press and hold the “SET” 

button. When the “SET” button is pressed, the display will show 

the set temperature. While holding the “SET” button, press the 

“WARMER” or “COLDER” buttons to adjust set temperature.

The available temperature range of the refrigerator is 35° to 43°.

It may take up to 24 hours for your refrigerator to reach desired 

temperature. This will depend on amount of content loaded and 

number of door opening and closings. 

For best results allow refrigerator to “pull down” to desired set 

point before loading. Once contents are loaded, allow at least 

48 hours for temperature to stabilize before making any adjust-

ments to the set point.

Your MicroSentry™ refrigerator control will monitor refrigerator 

function and alert you with a series of audible and visual alarms.

                      • 

Door Ajar Alarm: If the door has been left

                        open for over five (5) minutes, the alarm 

                        will sound in one (1) second intervals. The

display panel will flash “do” and the LED light will be a steady 

amber color. This will stop as soon as the door is closed.

                     • 

Temperature Sensor Fault: If the controller 

                         detects that a temperature sensor is

                         not properly functioning, a temperature 

                         sensor alarm will sound. “E1” or “E2” will flash on

                         the display, and an audible alarm will sound.

                         Please call AGA MARVEL Customer Service or your 

dealer if this error code is displayed.

Press any key to mute the audible portion of an alarm.

NOTE-This action will only mute the alarm. If the condition that 

caused the alarm continues, the alarm code will continue to flash 

and will sound for 20 seconds every 60 minutes.

Light Switch

Door Switch

Control

Figure 7

close-up of 

control