InSinkErator F-201R Manual Do Utilizador

4

Personal Injury: Do not locate filter above an outlet or other

electrical device. Install head and bracket so that connections 

require no stretching, kinking or pinching of tubing.

Property Damage: Tube runs need to form to the cabinet’s

contours to allow storage space with no sharp bends. Tubes

need clean, perpendicular, burr-free cuts to ensure a true fit.

A

B

■

■

Determine length of tubing required,
then cut to length making sure the
cut is perpendicular and burr-free.

■

■

Insert a white 3/8" tube into inlet
side of filter head until it stops. 
Press in again to ensure a secure fit.

■

■

Insert the other white 3/8" tube 
into outlet side of filter head
until it stops. Press in again to 
ensure a secure fit.

■

■

Mark hole locations for filter head
and bracket in a spot that allows for
filter replacement.

■

■

Drill 1/8" starter holes and attach
bracket to wall with wood screws,
turning until snug. 

■

■

Remove red filter cap, insert filter
cartridge into filter head and twist
clockwise until “LOCK” arrow on the
filter aligns with arrow on bracket.

■

■

To redirect filter replacement water
discharge, place the supplied 6" 
clear tube over vent hole on the 
left side of filter head.

C

■

■

Insert the copper tube(s) from the 
water dispenser into the 3/8" to 1/4"
quick-connect fitting. 

■

■

Connect the white 3/8" tube 
from the right outlet on the filter 
head into the quick-connect fitting
until it stops. Press in again to
ensure a secure fit.

from water 
supply line

to other 
plumbing 
fixture

Discharge

tube

From water

supply line

To faucet

Plug

From filter

From filter

D

1

INSTALLING FILTRATION SYSTEM

Installation must comply with all state and local laws and regulations.

INSTALLING FILTRATION SYSTEM