InSinkErator F-201R Manual Do Utilizador

Property Damage: Join remaining tube 

to cold water supply only.

■

■

Turn on the cold water supply. 

■

■

Run water through your unit for 

at least 3 minutes to flush lines and filter.

■

■

Check all connections to ensure they are
tight and that there are no leaks.

3

2

Brass Nut

Ferrule

Brass Insert

■

■

At the end of the white 3/8" tube from the
filter, slide the supplied brass nut and
ferrule over the tube and then push in the
brass tube insert.

■

■

If not already equipped, install a
compression, T-fitting or saddle valve 
onto the cold water supply line.

■

■

Insert the white 3/8" tube into the 3/8"
compression fitting and tighten.

5

FINAL WATER CONNECTION

FILL TANK & THEN CONNECT POWER

If leaks present themselves, turn off water 

supply, tighten fittings and repeat step 3.

 This 

cartridge provides mechanical and chemical reduction of dirt/rust, taste/odor, chlorine and particulates.

  500 gallons, depending on local water conditions. Note that while the testing was performed under 

standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be 
installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty 
card for warranty. For service and parts, contact your local dealer or InSinkErator® directly at 1-800-558-5700.

    

 Service flow of 0.75 gpm, community or 

private well water supply, water pressure of 30-125 psi, water temperature of 33˚F–100˚F. Except as noted, all 
testing performed at pH = 7.5  ±  0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚± 3˚C.

System Tested and Certified by NSF International 
against NSF/ANSI Standard 42 for the reduction of 
Chlorine taste and odor and Nominal Particulate Class I. 

FINAL WATER CONNECTION

TURN ON WATER & CONNECT POWER