Lucent Technologies Release 8.2 Manual Do Utilizador
Configuration 3: R8si<—x.25 —> R8r Gateway
<—ethernet—> R8si
<—ethernet—> R8si
3
C-LAN Administration
Administration for Network Connectivity
CID: 77730
555-233-504 — Issue 1 — April 2000
120
Switch 3 Task — Assign Link via ethernet Data Module to the LAN
This task administers an ethernet data module on Switch 3 for the ethernet connection
to Switch 1. The data module associates a link number with a port address, extension
number, and node name for the C-LAN port used for this connection.
to Switch 1. The data module associates a link number with a port address, extension
number, and node name for the C-LAN port used for this connection.
Begin
Steps
> Open Data Module form — enter
a da n
> Enter values.
> Submit the screen
End
add data module next
Page 1 of x
DATA MODULE
Data Extension: 4531
Name: ethernet on link 3
BCC: 2
Type: ethernet
Port: 01a1017
Link: 3_
Port: 01a1017
Link: 3_
Network uses 1’s for broadcast addresses? y
Field
Conditions/Comments
Type:
This indicates the data-module type for this connection.
Port:
In this example, the C-LAN circuit pack is in slot 01a10; the
ethernet connection is through port 17.
ethernet connection is through port 17.
Link:
The link number must be in the range 1 – 25 (for R8si), not
previously assigned on this switch.
previously assigned on this switch.
Name:
Information-only; appears in the “list data module” command list.
Network
uses 1’s for
broadcast
addresses?
uses 1’s for
broadcast
addresses?
Leave the default (
y
) if the private network contains only
DEFINITY switches and adjuncts. Set to
n
only if the network
includes non-DEFINITY switches that use the 0’s method of
forming broadcast addresses. See Appendix A, “Data Module -
type ethernet” for more information about this field.
forming broadcast addresses. See Appendix A, “Data Module -
type ethernet” for more information about this field.