Lucent Technologies Release 8.2 Manual Do Utilizador

Configuration 3: R8si<—x.25 —> R8r Gateway
<—ethernet—> R8si

121

Administration for Network Connectivity

555-233-504 — Issue 1 — April 2000

CID: 77730

C-LAN Administration

Switch 3 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on
Switch 3.

Begin

Steps

> Open Processor Channel Assignment form — enter

ch com p

Note:

The Processor Channel number, the Interface Channel number, and the
Local and Remote Session numbers do not need to be the same number
but they should be made the same whenever possible to simplify network
“bookkeeping” and diagnostics.

> Enter values

change communications-interface processor-channels
Page 1 of X

PROCESSOR CHANNEL ASSIGNMENT

Proc Gtwy

Interface

Destination Session Mach

Chan Enable Appl. To Mode Link/Chan

Node Port Local/Remote ID

_______

_ __ _____ ____________ 0____ ___ ___ __

_______

_ __ _____ ____________ 0____ ___ ___ __

31: y dcs____

node-1______ 5003 31_ 31_ 1_

32: y dcs____ c

3_ 0

node-1______ 6002

32_ 32_ 2_

256:

_______

_ __ _____ ____________ 0____ ___ ___ __

Field

Conditions/Comments

For Processor Channel 31

: (ethernet connection to Switch 1)

Enable

Set to

Appl.

Indicates that this connection will carry DCS data.

Mode

Node-3 is the “client” for this session. Set node-1 to
“server” (

Interface Link

This must match the link number assigned on the node-3
data module screen.

Interface Chan

A value of

allows any available interface channel to be

used for this connection. This number must match the
Destination Port number on the Switch-1 Processor
Channel screen.

Destination Node

Name of the far-end node for this channel. This must be a
name entered on the Node Names screen.

1 of 2