Lucent Technologies Release 8.2 Manual Do Utilizador
Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)
<—ethernet—> R8si
<—ethernet—> R8si
195
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000
CID: 77730
3
C-LAN Administration
Switch 2 Task — Assign IP Route to node-3
This task specifies a route for packets handled by node-2 that are destined for node-3.
An IP route is required for this route because there are intermediate nodes between
node-2 and node-3.
An IP route is required for this route because there are intermediate nodes between
node-2 and node-3.
Begin
Steps
> Enable the ppp link on the node-2 data module screen:
ch da 3020
, set Enable Link? to
y
.
> Open the IP Routing form — enter
a ip n
[The system assigns the route number 4.]
> Enter values
> Submit the screen
End
add ip-route next
Page 1 of 1
IP ROUTING
Route Number: 4
Destination Node: node-3____
Gateway: node-1a-ppp
C-LAN Board: 1a04
Metric: 0
Destination Node: node-3____
Gateway: node-1a-ppp
C-LAN Board: 1a04
Metric: 0
Field
Conditions/Comments
Destination Node:
The name of the node at the destination of this route.
Gateway:
Node name of the gateway by which the destination node is
reached for this route.
reached for this route.
C-LAN Board:
The location of the C-LAN circuit pack that provides the
interface for this route. For simple routes, the gateway node
is on this circuit pack.
interface for this route. For simple routes, the gateway node
is on this circuit pack.
Metric:
Enter
0
.
Appendix A for more
information on the use of the Metric field.