Lucent Technologies Release 8.2 Manual Do Utilizador

Administration for Network Connectivity

CID: 77730

555-233-504 — Issue 1 — April 2000

426

To confirm that all ports allowed under your license are available, start at the 
Windows NT desktop:

Double-click the 

 icon.

IP Trunk Configuration Manager appears.

Click the 

 tab.

The Telephony property page appears.

Click 

.

Verify that the number of enabled port matches the maximum your license allows. 
If not, contact your Lucent representative.

Click 

 to close Configuration Manager.

The following procedures must be performed on the NT server to administer IP Trunks.

To administer routing for outgoing (originating) calls, start at the Windows NT 
desktop:

Double-click the 

icon.

IP Trunk Configuration Manager appears.

Click the 

 tab.

The Telephony property page appears.

In the Maximum Digits to be collected box, type the number of digits that the 
switch will forward to the IP Trunk software.

The Maximum Digits to be collected field entry will be determined by the type of 
dialing, or types of dialing that will be performed using IP Trunking. Refer to the 
Dial/Routing Plan Worksheets, or if extension dialing is used, this field would be 
the extension length in the DEFINITY private network.

Set this field no higher than the maximum length of the digit string the switch 
sends. Otherwise, the IP Trunk application waits several seconds for 
additional digits and users experience delays.

Click the 

 tab.