Tektronix 2200 Manual Do Utilizador

4-14

1. To install the replacement supply in the frame, slide it into place from 

the front of the frame, secure it with the two screws previously 
removed, and close the front door.

2. Disconnect the wide connector from the circuit board. (It’s still 

connected in the Todd frame, even though you removed it in the 
Pioneer frame.)

3. At the terminal block you just installed on the Todd power unit, 

connect the blue and brown AC power wires you previously 
disconnected from the Pioneer supply, as shown in 

. (These 

may be reached and pushed back into the power supply area from the 
front of the frame if necessary.)

4. Connect the blue wire coming out of the frame to the terminal with the 

blue jumper wire; connect the brown wire coming out of the frame to 
the terminal with the brown jumper wire.

Connect

2 Connectors

to

Signal Processor

 or Upper

Power Supply

Connect

Multi-Wire

Connector

to

Circuit Board

Connect

Blue Wire

Connect

Brown Wire

2405-02