Tektronix 2200 Manual Do Utilizador
2-65
Cable Connections
Connector Installation
The connector that plugs into the Remote Aux Panel has screw clamps to
hold the wires. Paying attention to polarity (see
hold the wires. Paying attention to polarity (see
into the appropriate holes and screw down the clamps. If there is another
control panel, the cable to the next panel must also be inserted into this
connector. The D connector on that cable must be cut off, and the wires for
the next panel must be stripped and inserted into the same holes before the
screws are tightened. Make sure the polarity is correct. Refer to
control panel, the cable to the next panel must also be inserted into this
connector. The D connector on that cable must be cut off, and the wires for
the next panel must be stripped and inserted into the same holes before the
screws are tightened. Make sure the polarity is correct. Refer to
If you are building your own cable, use a shielded twisted-pair such as
Belden 8451 and refer to
Belden 8451 and refer to
Table 2-5. Cable Polarity
Panel Connector
D-Connector
Factory Supplied Cable
+ (Plus)
3 and 7
Red
– (Minus)
2 and 8
Black
Shield
9
Shield
Figure 2-32. Remote Aux Panels Connection
KEEP SHIELD CONNECTION AS SHORT AS POSSIBLE
From Switcher or
Previous Panel
Previous Panel
To Next Panel
(if any)
To Pin 9 of
D Connector
(SHIELD)
D Connector
(SHIELD)
To Pins 2 and 8 of
D Connector (–)
D Connector (–)
To Pins 3 and 7 of
D Connector (+)
D Connector (+)