TP-LINK T1500-28PCT Manual Do Utilizador
88
T1500-28PCT(config-if)# storm-control multicast
storm-control unicast
Description
The
storm-control unicast command is used to enable the unicast control
function. To disable the unicast control function, please use
no storm-control
unicast command. Unicast control function allows the switch to filter UL frame
in the network. If the transmission rate of the UL frames exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
in the network. If the transmission rate of the UL frames exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control unicast [rate rate]
no storm-control unicast
no storm-control unicast
Parameter
rate —— Select the bandwidth for receiving UL-Frame on the port. The packet
traffic exceeding the bandwidth will be discarded. By default, the value is
“128K”.
traffic exceeding the bandwidth will be discarded. By default, the value is
“128K”.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the unicast control function for port 5:
T1500-28PCT(config)# interface fastEthernet 1/0/5
T1500-28PCT(config-if)# storm-control unicast
bandwidth
Description
The
bandwidth command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use
no bandwidth
command.
Syntax
bandwidth {[ ingress ingress-rate ] [ egress egress-rate ]}
no bandwidth { all | ingress | egress }
no bandwidth { all | ingress | egress }