Zebra Technologies 105SLTM Manual Do Utilizador
Troubleshooting
Miscellaneous Printer Problems
Miscellaneous Printer Problems
128
11342L-001 Rev. A
105SL User Guide
6/30/06
Miscellaneous Printer Problems
identifies miscellaneous problems with the printer, the possible causes, and the
recommended solutions.
Table 17 • Miscellaneous Printer Problems
Problem
Possible Cause
Recommended Solution
The LCD displays a
language that I
cannot read
language that I
cannot read
The language parameter was
changed through the control
panel or a ZPL command.
changed through the control
panel or a ZPL command.
1.
Press
SETUP/EXIT
to enter configuration
mode.
2.
Press
MINUS (-)
.
The printer displays the
LANGUAGE
parameter in the current language. Even if
you cannot recognize the characters
displayed, you can still scroll to another
language.
you cannot recognize the characters
displayed, you can still scroll to another
language.
3.
Press
PLUS (+)
or
MINUS (-)
to scroll
through the choices.
4.
Press
SETUP/EXIT
.
The LCD displays
SAVE CHANGES
in the
original language.
5.
Press
NEXT/SAVE
to exit configuration
mode and save the changes (if the language
does not change, you may need to scroll to a
different save option by pressing
does not change, you may need to scroll to a
different save option by pressing
PLUS (+)
or
MINUS (-)
in the previous step).
6.
Repeat this process, if necessary, until you
reach the desired language.
reach the desired language.
The LCD is missing
characters or parts of
characters
characters or parts of
characters
The LCD may need replacing.
Call a service technician.
Changes in
parameter settings
did not take effect
parameter settings
did not take effect
Parameters are set incorrectly.
1.
Set parameters and save permanently.
2.
Turn the printer off (O) and then on (I).
A ZPL command turned off the
ability to change the parameter.
ability to change the parameter.
Refer to the ZPL Programming Guide, or call a
service technician.
service technician.
A ZPL command changed the
parameter back to the previous
setting.
parameter back to the previous
setting.
Refer to the ZPL Programming Guide, or call a
service technician.
service technician.
If the problem continues, there
may be a problem with the
main logic board.
may be a problem with the
main logic board.
Call a service technician.