Ricoh AP610N Manual Do Utilizador

Error & Status Messages on the Control Panel

55

Hardware Problem

Option RAM

The printer identified an op-
tional RAM error.

Turn the power off, and then on. Re-
move and re-install the optional RAM. 
If the message appears again, contact 
your sales or service representative.

See “Attaching Memory Unit Type C 
256MB (SDRAM Module)”, Setup 
Guide.

Turn off the power, remove the mem-
ory unit, and then turn on the power.

❒ If you remove the memory unit, 

you must set up the option with 
the printer driver. 

❒ In this case, you might not be able 

to print complex print jobs.

Hardware Problem

Parallel I/F

There is a problem with the 
parallel interface.

If you use the parallel I/F, replace the 
interface cable that caused the error. If 
the message appears again, contact 
your sales or service representative.

Hardware Problem

USB

There is a problem related to 
the Universal Serial Bus Con-
nection and Hardware.

Turn the power off, and then on. If the 
message appears again, contact your 
sales or service representative.

Hardware Problem

Wireless Board

An error was detected in the 
IEEE 802.11b interface unit or 
the Bluetooth interface unit.

Turn the power off, and then on. Re-
move and re-install the IEEE 802.11b 
interface unit or the Bluetooth inter-
face unit correctly.

If the message appears again, contact 
your sales or service representative.

See “ Attaching 802.11b Interface Unit 
Type F ” or “Attaching Bluetooth In-
terface Unit Type C ”, Setup Guide.

Hardware Problem

Wireless Card

The IEEE 802.11b interface unit or 
the Bluetooth interface unit could 
not be detected when the power 
was turned on. The IEEE 802.11b 
interface card or the Bluetooth in-
terface card was removed after 
the power was turned on. An er-
ror was detected in the IEEE 
802.11b interface card or the Blue-
tooth interface card.

Turn the power off, and then on. Re-
move and re-install the IEEE 802.11b 
interface unit or the Bluetooth inter-
face unit correctly.

If the message appears again, contact 
your sales or service representative.

See “ Attaching 802.11b Interface Unit 
Type F ” or “Attaching Bluetooth In-
terface Unit Type C ”, Setup Guide.

HDD Full

The maximum HDD area size for 
form/font has been exceeded.

Delete the disused form/font types.

The optional Hard Disk Drive is 
full. The sample print job or 
locked print job to be sent from 
the computer is too large to store.

Delete any unnecessary stored files.

KirP4GB_Mainte-F6_FM_forPaper.book  Page 55  Thursday, May 12, 2005  11:48 AM