Ricoh AP610N Manual Do Utilizador
Troubleshooting
56
5
HDD not Installed
You cannot print the sample
print and the locked print jobs,
because the optional Hard Disk
Drive is not installed.
print and the locked print jobs,
because the optional Hard Disk
Drive is not installed.
Install the Hard Disk Drive.
See “Attaching Hard Disk Drive Type
2600”, Setup Guide.
2600”, Setup Guide.
Hex Dump Mode
The printer is in Hex Dump Mode. No action required.
Invalid Data
Power Off On
The printer has received irreg-
ular data.
ular data.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
message appears again, contact your
sales or service representative.
Invalid Password
Try again
The password entered using
the control panel is not correct.
the control panel is not correct.
Enter the correct password using the
control panel.
control panel.
Load Correct
Size Paper
/ Press #
to continue
The paper size setting on the
tray differs from that of actual
paper size in the tray.
tray differs from that of actual
paper size in the tray.
Load { paper size } paper of the select-
ed feed direction and paper size into
the tray. Printing will not automati-
cally resume if the paper size and di-
rection setting is incorrect. Make sure
that the paper feed directions set in
the printer driver and on the control
panel are the same. There are two
methods to resume printing.
ed feed direction and paper size into
the tray. Printing will not automati-
cally resume if the paper size and di-
rection setting is incorrect. Make sure
that the paper feed directions set in
the printer driver and on the control
panel are the same. There are two
methods to resume printing.
A
Use the control panel to set the cor-
rect paper size and direction of the
paper in tray. Then Press the {# En-
ter}
rect paper size and direction of the
paper in tray. Then Press the {# En-
ter}
key .
B
Press {Form Feed} and select the
tray with the control panel.
tray with the control panel.
Load Paper
or Form Feed
/ Paper Size:
Paper Type:
The paper type and size set-
tings for this tray do not match
the size and type of paper actu-
ally loaded.
tings for this tray do not match
the size and type of paper actu-
ally loaded.
Load paper into the tray indicated,
then press the {# Enter} key to resume
printing. Or press {Form Feed} and se-
lect the tray that holds a different type
of paper. To cancel printing, press {Job
Reset}
then press the {# Enter} key to resume
printing. Or press {Form Feed} and se-
lect the tray that holds a different type
of paper. To cancel printing, press {Job
Reset}
. Then Press the {# Enter} key .
Load Paper:Tray #
or Form Feed
/ Paper Size:
Paper Type:
There is no paper left in this
tray.
tray.
#: tray number
Load paper into the tray indicated.
Menu Protected
Cannot change
The menu is protected and the
settings cannot be changed.
settings cannot be changed.
Wait for two seconds until the previ-
ous display appears.
ous display appears.
No Files exist
There are no files available for
the sample print job or the
locked print job.
the sample print job or the
locked print job.
Wait for two seconds until the previ-
ous display appears.
ous display appears.
Offline
The printer is offline and can-
not print data.
not print data.
Press {Online} key.
Messages/Second
messages
messages
Description
Solution
KirP4GB_Mainte-F6_FM_forPaper.book Page 56 Thursday, May 12, 2005 11:48 AM