Extreme networks 10018 Manual Do Utilizador
1 Holding the SFP module by its sides, insert the SFP module into the port on the switch.
2 Slide the SFP module into the port until you hear it click.
2 Slide the SFP module into the port until you hear it click.
If the SFP module has a handle, push up on the handle to secure the SFP module.
Note
Disconnect fiber-optic cable from an optical SFP module before removing the SFP module
from the port.
Disconnect fiber-optic cable from an optical SFP module before removing the SFP module
from the port.
Connecting Fiber Cables
Before you connect fiber cables to the dual-speed 100FX/1000LX SFP module or the LX100 SFP
module, note the following information about these SFP modules
module, note the following information about these SFP modules
100FX/1000LX SFP Module
The 100FX/1000LX SFP module complies with the 100FX-SMF standard.
In order to use the 100FX/1000LX SFP module in 100FX-MMF operation, a minimum attenuation of 6
dB is required. After the SFP module is installed, connect a 6-dB attenuator to the transmitter side (Tx)
of the SFP module. Then connect the attenuator to the single-mode end of a mode conditioning patch
cord. The mode conditioning patch cord transitions the SFP module from SMF to MMF operation.
dB is required. After the SFP module is installed, connect a 6-dB attenuator to the transmitter side (Tx)
of the SFP module. Then connect the attenuator to the single-mode end of a mode conditioning patch
cord. The mode conditioning patch cord transitions the SFP module from SMF to MMF operation.
LX100 SFP Module
To prevent permanent damage to the LX100 SFP module, always check the optical input power of the
receiver before you insert the fiber cable.
receiver before you insert the fiber cable.
The maximum optical input power is -9 dBm. If you use an optical loopback for diagnostics, the
loopback requires a minimum of 12 dB optical attenuation. The recommended attenuation range is 12 to
20 dB.
loopback requires a minimum of 12 dB optical attenuation. The recommended attenuation range is 12 to
20 dB.
Remove an SFP Module
1 Disconnect the optical cable from the SFP module.
2 Unlatch the SFP module in one of the following ways:
2 Unlatch the SFP module in one of the following ways:
hold the black plastic tab at the bottom of the connector.
, rotate the front handle down.
3 Pull the SFP module out of the port on the switch.
Extreme Networks SFP and SFP+ Modules
Pluggable Hardware Installation Guide
25