Extreme networks 10018 Manual Do Utilizador
•
BlackDiamond X8 switch
•
BlackDiamond 8900-40G6X-xm I/O module
•
SummitStack-V80 stacking module installed in a Summit X460 series switch
•
VIM2-SummitStack-V80 module installed in a Summit X480 series switch
•
VIM3-40G module installed in a Summit X650 series switch
•
VIM4-40GX module installed in a Summit X670V-48x switch
LR4 QSFP+ Module
The LR4 QSFP+ module provides a 40-Gbps optical connection using LC optical connectors. This
optical module integrates four data lanes in each direction with 40 Gbps aggregate bandwidth. Each
lane can operate at 10.3125 Gbps up to 10Km using single mode fiber. The LR4 QSFP+ module conforms
to the 802.3ba (40GBASE-LR4) standard.
optical module integrates four data lanes in each direction with 40 Gbps aggregate bandwidth. Each
lane can operate at 10.3125 Gbps up to 10Km using single mode fiber. The LR4 QSFP+ module conforms
to the 802.3ba (40GBASE-LR4) standard.
The LR4 QSFP+ module is supported in the following Extreme Networks switches and components:
•
BlackDiamond X8 switch
•
BlackDiamond 8900-40G6X-xm I/O module
•
SummitStack-V80 stacking module installed in a Summit X460 series switch
•
VIM2-SummitStack-V80 module installed in a Summit X480 series switch
•
VIM3-40G module installed in a Summit X650 series switch
•
VIM4-40GX module installed in a Summit X670V-48x switch
Install a QSFP+ Module
You can install or remove QSFP+ modules in your switch without powering off the system.
Warning
QSFP+ modules contain Class 1M lasers. Invisible laser radiation can occur when laser
connections areunplugged. Do not stare into the beam. This device is compliant with IEC
60825-1 Amendment 2 and CFR21Section 1040.
QSFP+ modules contain Class 1M lasers. Invisible laser radiation can occur when laser
connections areunplugged. Do not stare into the beam. This device is compliant with IEC
60825-1 Amendment 2 and CFR21Section 1040.
1 Remove the QSFP+ module from its antistatic container and remove the dust covers from the
module optical connector.
If your module has a protective pad covering the card-edge connector, remove it. Store the
antistatic container, dust covers, and card-edge connector protective pad in a clean location from
which they can be easily retrieved if you need to uninstall the module.
If your module has a protective pad covering the card-edge connector, remove it. Store the
antistatic container, dust covers, and card-edge connector protective pad in a clean location from
which they can be easily retrieved if you need to uninstall the module.
2 Remove any rubber dust covers from the port where you are installing the QSFP+ module.
3 Holding the QSFP+ module by its sides, insert the QSFP+ module into the port on the switch or
3 Holding the QSFP+ module by its sides, insert the QSFP+ module into the port on the switch or
module.
QSFP+ Modules
Pluggable Hardware Installation Guide
27