Vanguard Managed Solutions 7300 Series Manual Do Utilizador
Vanguard 7300 Installation
3-19
Attaching a Vanguard 7300 AC Power Cord
Attaching a Vanguard 7300 AC Power Cord
Introduction
This section explains how to attach an AC Power Cord to a Vanguard 7310 or 7330.
Attaching the
Power Cord
Power Cord
Attach the supplied power cord to the rear of the AC power supply and plug it in.
The Vanguard 7310 Version 1 power receptacle is on the back of the enclosure. See
Figure 3-13.
The Vanguard 7310 Version 1 power receptacle is on the back of the enclosure. See
Figure 3-13.
Figure 3-13. Vanguard 7310 Version 1 - Power Connector and On/Off
Switch
Switch
Version 1
For the Vanguard 7330 Version 1 routers, there are two AC power cords on the back
of the enclosure, one for each of the two AC power supplies, as shown in
Figure 3-14. The power switch for the Vanguard 7330 is on the chassis front panel.
of the enclosure, one for each of the two AC power supplies, as shown in
Figure 3-14. The power switch for the Vanguard 7330 is on the chassis front panel.
Figure 3-14. Vanguard 7330 Version 1 - Power Connectors
Power
Switch
Dual Earth
Ground
ESD Bond
Point
AC Power
Receptacle
AC Power Cord
Receptacles