EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge Manual Do Utilizador

Installation of the Outdoor Wireless Client Bridge requires the following: 
 

1.  A Windows-based PC/AT compatible computer or Ethernet 

data device with an available RJ-45 Ethernet port to run the 
configuration program or with TCP/IP connection to the 
Ethernet network. 

2.  A 10/100Base-T Ethernet RJ-45 Ethernet cable is connected to 

Ethernet network. 

3.  A RS-232 consol port cable is connected to PC/AT compatible 

computer. 

4.  An AC power outlet (100~240V, 50~60Hz) supplies the power. 

 

The Wireless client bridge is equipped with an Inline Power Injector module. 
The Inline Power Injector (PoE) delivers both data and power to Wireless 
client bridge unit via a signal Ethernet cable, and gives the following 
benefits to improve the performance vs. installation cost ratio.  

 

1.  This works great in areas where you may not have power 

and/or Ethernet easily accessible, like house roof.  

2.  This also allows you to place the Wireless client bridge unit 

closer to the antenna, more easily thus reducing signal loss 
over antenna cabling. 

3.  Ethernet signal travels well over CAT 5 cable but 2.4GHz 

signal doesn't do as well over antenna cabling.  

4.  Ethernet cabling is much cheaper than Antenna cabling. 

 

 
This chapter describes the procedures of installing the Wireless client 
bridge. 
 

After unpacking the system, make sure the following items are present and 
in good condition. 
 

1.  Wireless client bridge Outdoor Wireless Client Bridge unit 
2.  AC/DC adapter 100~240VAC, 50~60Hz with wall-mount plug 

and DC plug power cord 

3.  Inline Power Injector (PoE) 24VDC, 830mA 
4.  Water protect kit consists of three of components 
5.  Grounding wire 1.8m 
6.  User manual CD-disc 
7.  Wall/mast mounting kit, including one (1) band clamp 

 

    

            

             

     

 

 
 

   

        

     

                      

 
 
 

2

3

4

5

7

6

1