Heath Zenith 598-1143-01 Manual Do Utilizador

-4-

Chime does not sound and strobe does not flash:
•  Make sure push button and chime codes are the same (See pages 2 and 3).
•  Check orientation of push button battery (See page 3).
•  Check push button battery charge, replace if necessary.
Batteries seem OK, but the chime and strobe do not work when installed:
•  Do  not  mount  chime  or  push  button  on  metal  or  near  metal  studs. This 

reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to 
move chime or push button off metal surface.

•  Concrete floors may reduce range. Move chime away from floor.
•  Try locating chime closer to push button.
The range of the wireless chime can vary with location, temperature and bat-
tery condition.

This device complies with Part 15 of the FCC Rules and RSS-210 of Industry 
Canada. Operation is subject to the following two conditions: (1) this device may 
not cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved by 
the party responsible for regulatory compliance could void the user’s authority 
to operate the equipment.

If you experience a problem, follow this guide. You may also want to visit our 
Web site at: 

www.hzsupport.com. If the problem persists, call* for assistance 

at 

1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:

HeathCo LLC
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service
* If contacting Technical Service, please have the following information available: 
Model Number, Date of Purchase, and Place of Purchase.