Casablanca Fan Company C8U47M AT1206 Manual Do Utilizador

CEILING HARDWARE (not to scale)

WARNING!

Support directly to building  structure only.

Using Existing Ceiling Fixture Outlet Box

After turning the power OFF at its source (either circuit 
breaker or fuse box), lower the old fi xture and disconnect 
the wiring. Check the ceiling fi xture outlet box to be sure 
that it is marked “Approved for Ceiling Fan Mounting.” If 
it is not, a new box must be installed. 

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fi xture located where you wish 
to place your Casablanca fan, an approved ceiling fi xture 
outlet box must be installed and wired.

Note: Th

  e weight of this fan is 34 pounds.

Note: After removing the old fi xture, check the outlet box 
to ensure it is supported by a joist or beam across its upper 
surface. If not, a 2"x4" stud must be installed.

Step 1a. Remove the knockout plug in the center of the 
outlet box or drill a 

1

/

2

-inch hole for the lag screw to pass 

through. Th

  en drill a 

1

/

4

-inch guidehole into the joist or 

beam to a depth of 3 inches.

Step 1b. Route the outlet box wires through the keyhole 
slot of the crossbar mounting bracket as shown. Attach 
the crossbar mounting bracket to the outlet box with the 
screws provided, assuring that the outlet box wires are not 
pinched by the washer. 

CAUTION: 

To reduce the risk of personal injury, use only the 
mounting hardware provided with the approved 
outlet box to install the crossbar mounting 
bracket.

WARNING!

To reduce the risk of fire, electrical shock, or 
personal injury, mount to outlet box marked 
“Acceptable Fan Support of 22.7 kg (50 lbs.) or 
less” using the mounting hardware provided with 
the outlet box.