Vertex Standard FT-1000MP Manual Do Utilizador
page 31
MARK-V FT-1000MP Operating Manual
LCD B
ARGRAPH
M
ETER
I
NDICATIONS
20. TUNER
This indicator comes on when the automatic an-
tenna tuner (ATU) is activated and in-line.
21. WAIT
Appears when the ATU is seeking the best imped-
ance match with the antenna. It also flashes each time
the transceiver microprocessor sends frequency up-
date data to the ATU microprocessor (while you tune).
the transceiver microprocessor sends frequency up-
date data to the ATU microprocessor (while you tune).
22. HI SWR
Appears when an abnormally high SWR condition
exists that cannot be matched below 3.0:1.
23. RX/CLAR/TX
These appear indicating the selected Clarifier func-
tion (Rx, Tx or both). The Clarifier offset frequency ±9.99
kHz) is shown in the sub-display immediately to the
right.
kHz) is shown in the sub-display immediately to the
right.
24. ANT A/B
Indicates the antenna selected for operation (A or
B) by the front panel ANT [A/B] switch (see item 18 on
page 23).
page 23).
25.
CAT
External computer control of the transceiver is ac-
tive.
26. CLEAR
Indicates the selected memory channel is not yet
filled with data.
27. OFFSET
When enabled, this field shows the frequency dif-
ference (split offset) between Main VFO-A and Sub
VFO-B.
VFO-B.
28. Multi-Display Window
Displays either the Clarifier offset, memory chan-
nel frequency, split frequency offset, or CW pitch.
29. MEM F
Appears when the memory channel frequency ap-
pears in the multi-display panel.
30. GROUP
When the [M GRP] button is pressed, this indicates
that the “memory recall” mode is engaged, and that
scanning is limited to those memories in the currently-
selected group.
scanning is limited to those memories in the currently-
selected group.
31. TRACK
Appears when the VFO Tracking feature is acti-
vated.
32. Memory Channel Box
During normal operation, the currently-selected
memory group and memory channel number appear
here. With the Menu Programming mode active, menu
selection numbers are displayed.
here. With the Menu Programming mode active, menu
selection numbers are displayed.
33. M CK
Appears when the Memory Check mode is acti-
vated.
34. Sub Receiver S-Meter
Displays relative signal strength.
35. Sub Receiver Frequency Display
Displays the current sub-receiver frequency used
during dual receive operation, and the transmit fre-
quency during most split operation.
quency during most split operation.
36. LOCK
Appears when the Sub VFO tuning knob is disabled
(it still turns but does nothing).
37. Sub Receiver MODE
Displays the currently-selected operating mode for
the Sub receiver.