JVC VR-N900U Manual Do Utilizador

Basic Operation

Connect using the power cable supplied to an AC 120V -
240V 50Hz/60Hz outlet.

• A system check will run when the power is turned on.
• The [OPERATE] indicator will blink.
• After blinking, the [OPERATE] indicator will light up to

indicate that operation has been turned on.

• When the settings have been completed, recording

operation is started automatically with record control
mode.

• Do not disconnect the power cord nor turn the power

switch off while the system check is running or in the
OPERATE ON mode as this may cause a malfunction.

After blinking, the [OPERATE] indicator will go off.

• The recorded images may not play back properly if they

were not archived (

• It is recommended that an uninterruptible power supply

(UPS) be used to protect the hard disk from damage in
the event of a power failure. (

You are able to switch operation on or off.

• The [OPERATE] indicator will blink.
• The [OPERATE] indicator will light up, indicating that the

system is operable.

• When the power switch on the rear panel is turned on, the

system starts up to initiate a system check until the
OPERATE ON mode is activated.

• The [OPERATE] indicator will blink.
• The screen will go blank and the [OPERATE] indicator will

go off, indicating that operation has been turned off.

• Do not turn off the power until operation has been turned

off.

☞

☞