Manualsbrain.com
  1. Manuais
  2. Marcas
  3. Sanyo
  4. DSR - 300
  5. Manual Do Utilizador

Sanyo DSR - 300 Manual Do Utilizador

Download
Página de 136
MENU-SPECIFIC SETTINGS
2
108
English
NETWO
R
K
 
SE
T
T
IN
G
S
(when optional interface board is installed)
You can specify the position of motion sensors on screen 
as described below. Alarm images are recorded when a 
moving subject is detected at the specified position. 
11
Set the motion sensor level.
[Settings] (‹ indicates default setting.)
12
Click the location where the motion 
sensor is to be setup.
“ON” (displayed ) is displayed for the corresponding 
sensor. 
Click again to turn the sensor “OFF” (i.e., no display).
13
Click [SAVE]. 
The new settings are saved.
Set conditions for the display of data on the unit’s monitor 
by selecting “ON” or “OFF” for each item.
z
These settings apply to information displayed on the 
monitor connected to the unit, not to the PC monitor’s 
display information.
1
Select “ON” or “OFF” for each data 
display item.
2
Click [SAVE]. 
The on-screen data display conditions are set or modified.
Setting motion sensors
Setting
Description
‹
OFF
Motion sensing is not carried out.
1 to 10
Motion sensing will be carried out. Lower values 
correspond to higher sensitivities.
13
12 Setting example
11
10. DISPLAY SET
Item
Default 
setting
Description
DATE
ON
Sets whether the current date or recording 
date will be displayed.
TIME
ON
Sets whether the current time or recording 
time will be displayed.
QUALITY
ON
Sets the picture quality for recording or 
playback.
REC 
RATE
ON
Sets the recording rate for recording or 
playback.
ALARM 
COUNT
ON
Sets a maximum display quantity of 9,999, 
and when this is exceeded, counting 
restarts from 0.
ALARM 
TYPE
ON
Sets the alarm recording type.
z
“ALARM” is displayed for alarm 
recording.
z
“PRE” is displayed for pre-alarm 
recording.
1
2
e00_l8had_us_7.book  Page 108  Wednesday, March 10, 2004  2:47 PM