KVH Industries TracVision G4 Manual Do Utilizador

9. Determine your vessel’s current latitude and

longitude to the nearest degree.

10. Type 

where:

• AA = Latitude in degrees

• B = N (North) or S (South)

• CCC = Longitude in degrees

• D = E (East) or W (West)

11. Verify that the response shows the correct

parameters.

12. Type 

to restart/reinitialize the system.

The elevation motor is mounted to the inside of the support
frame. Machine screw/washer and stop nut sets hold the drive
motor in position to maintain proper tension on the toothed drive
belt. When adjusting belt tension or changing the belt, do not
remove the screws from the motor side, only loosen the external
nuts on the belt side. Figure 5-9 shows the arrangement of motor,
drive belt, and antenna pulley.

1. Using an 

11

⁄

32

" nut driver, loosen the four #8-32 self-

locking nuts until the motor is free to move
upward. Raise the motor to the top of the slots and
retighten the nuts to hold it there.

Maintenance

54-0147

Drive Motor

Pulley

Drive Belt

Motor Screws, Washers,

and Stop Nuts

Roller