KVH Industries TracVision G4 Manual Do Utilizador

6. Adjust the belt tension for a maximum of 

1

⁄

8

" (3 mm) deflection with moderate finger

pressure between the motor and antenna pulley.
Some readjustment may be necessary if the belt
tension results in excessive antenna reflector
vibration.

7. Connect the Elevation Motor Molex connector to

the main PCB and reinstall the PCB cover.

The LNB assembly receives power from the IRD via the RF PCB.
Be certain that the IRD is turned off or disconnected from its
power source before removing or reconnecting the LNB.

1. Using a 

7

⁄

16

" wrench, carefully disconnect both RF

connectors from the LNB. 

2. Loosen the two wing screws on the throat of the

choke feed until the LNB is free to slide out.
Withdraw the LNB as shown in Figure 5-10.

3. Insert the replacement LNB as far as it will go,

ensuring it reaches the bottom of the feedhorn. Be
careful not to puncture or dislodge the plastic seal
covering the LNB throat. Orient the LNB to align
with the strut holding the pair of RF cables.

4. Apply a small amount of thread-locking

compound (Loctite 425 or equivalent) to the wing
screw threads and tighten the screws to secure the
LNB in position.

5. Reattach the RF connectors to the LNB.

Maintenance

54-0147

Ensure that the IRD is turned off or
disconnected from its power source
before removing or reconnecting
the LNB.

Excessive belt tension may result in
antenna reflector vibration.