Woodstock m1043 Manual Do Utilizador
-18-
M1043 48" Pan and Box Brake
SE
RV
IC
E
SERVICE
Figure 17. Callouts showing where clamp
block and bending wing must be flush.
In order to achieve accurate bends, the top surface of
the bending leaf and the attached bending wing must be
flush with the top surface of the clamp block when the
bending leaf is in the down position (see
Figure 17).
Check for proper alignment by examining how the edges
of each component meet each other. Only perform the
instructions below if the top surfaces of these compo-
nents are NOT flush with each other.
There are two adjustments that can be made to align
the clamp block and bending wings. First, you can adjust
the ends of the bending leaf to make it even with the
clamp block; and second, you can straighten the main
body of the bending leaf or clamp block by tightening
a large nut on the center of a truss assembly, which is
mounted to each.
Aligning Bending Wing
Clamp
Block
Must Be
Flush Here
Bending
Wing