Woodstock m1043 Manual Do Utilizador
-19-
M1043 48" Pan and Box Brake
SE
RV
IC
E
To align the clamp block and bending wings, do these
steps:
1. Loosen the bending wing mounting bolts (Figure 18)
on each end of the brake.
2. Align the bending leaf flush with the clamp bar.
3. Tighten the bending wing mounting bolts.
• If the entire length of the bending leaf is flush
with the clamp block, then no further adjust-
ments are necessary.
• If the bending leaf is flush with the clamp block
at both ends but is not flush in the center, then
proceed to
Step 4.
4. Examine the center area where the clamp block and
bending wing meet.
• If the bending wing is lower than the clamp
block, then the truss nut under the bending wing
needs to be tightened (
Figure 19).
• If the bending wing is higher than the clamp
block, then the truss nut under the clamp block
needs to be tightened (
Figure 19).
5. Tighten the appropriate truss nut as determined
from
Step 4 until the bending wing and the clamp
block are flush with each other in the center.
Note: Make sure the truss nuts remain tight,
because they help stiffen the leaf.
Figure 18. Bending wing mounting bolts.
Figure 19. Truss nuts.