Samsung 100 Manual Do Utilizador

12

Failure to enter the time using the 24 hour clock will cause the date to change at
12:00 P.M. Open customer programming and follow the instructions below.

1. Press TRSF and then dial 505

Display shows

2. Enter the new time and date using 

the above format

3. Verify the time and date and reenter 

them if necessary

4. Press TRSF to store and exit 

programming OR press SPK to store 
and advance to the next program

If you have entered invalid data, you will receive an [ INVALID ENTRY ] message for
three seconds. Reenter the correct date and time. If the information you entered is
incorrect, repeat the procedure.

Individual keyset users can set or change their own individual passcodes. These
passcodes are used to lock and unlock keysets, override toll restriction and access
the DISA feature. At times, it may be necessary for the system administrator to
reset a station’s passcode to default “1234.”This program cannot be used to display
passcodes, only to reset them.

UP & DOWN - Select the extension number.
HOLD - Press to reset the passcode.

Open customer programming and follow the instructions below.

1. Press TRSF and then dial 101

Display shows

,,,,

sys_screen.qxp  5/11/2006  6:26 PM  Page 19

13

2. Dial the station number OR use the

UP and DOWN keys to scroll through

,,,,

the keyset numbers and press the 
right soft key to move the cursor right

3. Press HOLD to reset the passcode

4. Press the right soft key to return to 

step 2 OR press TRSF to store and exit 
programming OR press SPK to 
store and advance to the next program

This program is used to assign a character name or identification for each exten-
sion. You may assign a name of 11 characters long.

UP & DOWN - Used to scroll and move cursor.
KEYPAD - Used to enter characters.
HOLD - Press to clear entry.

Open customer programming and follow the instructions below.

1. Press TRSF and then dial 104

Display shows

2. Dial station number (e.g., 205)

OR press UP or DOWN to select the 
station and press the right soft key to 
move the cursor

3. Enter the station name using the 

procedure described on the next page

and press the right soft key to return to
step 2

sys_screen.qxp  5/11/2006  6:26 PM  Page 20