321 Studios QW5S Manual Do Utilizador
F1915 (2012 04)
Page 5 of 6
5.1 2”
Fiberglass – Pleated – MERV 8
6.0 HOT GAS REHEAT- (Factory installed option)
6.1
The dehumidification circuit incorporates an independent heat
exchanger coil in the supply air stream in addition to the standard
evaporator coil. This coil reheats the supply air after it passes over
the cooling coil, and is sized to nominally match the sensible cooling
capacity of the evaporator coil. Extended run times in
dehumidification mode can be achieved using waste heat from the
refrigeration cycle to achieve the reheat process, while at the same
time large amounts of moisture can be extracted from the passing air
stream.
exchanger coil in the supply air stream in addition to the standard
evaporator coil. This coil reheats the supply air after it passes over
the cooling coil, and is sized to nominally match the sensible cooling
capacity of the evaporator coil. Extended run times in
dehumidification mode can be achieved using waste heat from the
refrigeration cycle to achieve the reheat process, while at the same
time large amounts of moisture can be extracted from the passing air
stream.
7.0 CABINET COLOR – (Select One)
7.1
Washable Vinyl- Two-Tone Finish with Slate front and platinum sides
7.2
Slate Gray
7.3
Beige
9.0 CONTROLS – (Select one of the following factory mounted
control options)
9.1
None
9.2
Electronic non-programmable, manual changeover
9.3
Electronic programmable, auto changeover
9.4
Electronic programmable, auto changeover, with dehumidistat
9.5
Electronic non-programmable, auto changeover, with humidistat
10.0 ACCESSORIES
10.1 WALL SLEEVE
Wall sleeve shall be factory supplied and must be constructed of 16
gauge-galvanized steel, coated with an epoxy primer and baked-on
polyester enamel paint. It shall be designed to withstand a minimum
of 1000 hours of salt spray protection when tested per ASTM B117-03
standard. One sleeve size fits all models. Sleeve only required when
a ventilation option is selected.
gauge-galvanized steel, coated with an epoxy primer and baked-on
polyester enamel paint. It shall be designed to withstand a minimum
of 1000 hours of salt spray protection when tested per ASTM B117-03
standard. One sleeve size fits all models. Sleeve only required when
a ventilation option is selected.
10.2 Exterior Louver
Furnish factory louver designed for condenser air and outside air