Multi-Tech Systems iCell GPRS (MTSMC-G2-IP Manual Do Utilizador
Part 1 – AT Commands for All Universal IP Devices
Chapter 1 – General AT Commands for All Universal IP Devices
Universal IP AT Commands Reference Guide (Document S000457K)
13
+IFC – Set Flow Control
Description:
Turns flow control on and off.
Syntax:
AT+IFC=<flow control value>
Values:
0,0
Flow Control Off
2,2
Hardware Flow Control On
Default:
2,2
Hardware Flow Control On
+IPR – Set Serial Speed
Description:
Sets the serial speed.
Syntax:
AT+IPR=<serial speed value>
Values:
300 to 921600
Display
:
AT+IPR? Displays the current serial speed.
AT+IPR=? Displays a list of all possible values (serial speeds).
Default:
For All Products: 115200
#AUTORESET -
Reset the Processor at a Given Time
Description:
Set an amount of time when the modem will reset after no input has been detected on the serial
port.
Note:
This command is not supported on the SocketEthernet IP (MT100SEM-IP).
Syntax:
Set Value:
AT#AUTORESET=<time in minutes>
View Values:
AT#AUTORESET? or AT#VALL
Values:
0-65535 the time in minutes
From 1 to 5 numeric digits (0 to 9).
Default:
0
#DELFLASH – Erase Flash Memory Parameter Values
Description:
This command erases the contents of the flash memory and loads with defaults values.
Syntax:
AT#DELFLASH
Values:
No parameter values.