Emerson 1058 Manual Do Utilizador

10

Ensure that the 10-lead ribbon cable is properly
connected from the Profibus board to the 10-pin
shrouded connector labeled “DIG I/O” on the main 
printed circuit board (see photo).  

5. Connect the Model 1056 Profibus unit to a Profibus

network cable (purple) using standard Profibus
connectors and cable fittings.   Once power is wired
to the unit (as shown in photo), the Profibus-
configured Model 1056 is ready for power up and
communication on a Profibus network.

4. Slide the wired 4-lead terminal block onto the 4 pins

protruding from Profibus board on the left side.  

Note: the Profibus cable must be directed down-
wards.  The Profibus board can be partially or fully
removed to allow easy insertion of the 4-lead termi-
nal block onto the Profibus board.