Manual Do Utilizadoríndice analíticoTable of Contents6Safety2Section A - Installation7Section B - Operation15Section C - Accessories25Section D - Maintenance35Section E - Theory of Operation43Section F - Troubleshooting & Repair51Symptoms54Major physical or electrical damage is evident.54No welding output in all modes. The engine operates normally. The auxiliary output is normal.54No welding output in all modes. The engine operates normally. The auxiliary output is normal. (continued)55No welding output in all modes. Also no auxiliary power. The engine operates normally at approximately 3700 RPM.55No auxiliary power at the receptacles. The welding output is normal...56The machine has welding output but no control of output in some or all modes. The auxiliary power is normal.56The machine has low welding output and low auxiliary output.57The machine control is still active when the remote control unit is connected.57Machine seems to be locked into the CC mode of operation (stick mode.)57The wire feeder does not work when connected to the welder amphenol.58The battery does not stay charged.58The engine will not crank when the start button is pushed.59The engine cranks but will not start.59The engine will not develop full power.59The engine shuts down shortly after starting.60The engine will not idle down to low speed. The machine has normal weld output and auxiliary power.60The engine will not go to high idle when using the auxiliary power. Auxiliary power is normal when the IDLER switch is ...60The engine will not go to high idle when attempting to weld or when the auxiliary power is loaded.61The machine goes to low idle but does not stay at low idle.61The welding arc is “cold.” The engine runs normally. The auxiliary power is normal.62Section G - Electrical Diagrams119Tamanho: 3 MBPáginas: 134Language: EnglishAbrir o manual