Справочник Пользователя для Oregon Scientific SE300

22

EN

 NOTE  You can reset all the targets at any time by pressing and 
holding SET.
During the workout you can check the following information by 
pressing SET:
•   Target distance / time remaining and speed
•   Target distance / time remaining and heart rate
•   Clock and pace
•   Total distance for all targets done and average speed
•   Total time and average pace

 NOTE  The pace is the time (MM’SS”) required to finish one kilometer 
or mile.

To view the memory for target performance:
1.   Press ST / SP / + to pause or stop the target function.
2.   Press LAP / MEM / - to enter memory mode. Odometer will be shown.
3.   Press SET, “ALL” will flash. Then press ST / SP / + or LAP / MEM 

/ - to select viewing overall memory or an individual memory.

4.   Press SET to view each data.

For each individual target, the following data can be viewed:
•   Time elapsed and average speed
•   Distance traveled and average pace
•   Average heart rate

For overall performance, the following data can be viewed:
•   Total time elapsed and average speed
•   Total distance traveled and best pace
•   Average pace and average heart rate 

 NOTE   Odometer  is  the  total  distance  traveled  after  system  reset. 
It is shared with SPEED, TRAIN and CHRONO modes. To reset the 
odometer press and hold SET.

SE300_M_EN_USA.indd   22

8/31/06   12:13:09 PM