Справочник Пользователя для Oregon Scientific SE122

8

 When the alarm clock is activated, it will sound at 

the set time every day. Press any button to stop the alarm 
for that day. The alarm clock is still active and will set off 
again the following day.

1. Press MODE to Navigate to Chrono (stopwatch) mode.

KCAL

  

2.  Press ST/SP to start the stopwatch.
3. Press ST/SP to stop the stopwatch.
4.  Press and hold SET to reset.

 Unless you stop the stopwatch, “

” will blink in all 

modes to remind you that the stopwatch is still timing.

To access the full benefits of this product, set up your user data 

before you exercise. This will automatically enable the watch 
to calculate the level of calories burned when exercising. This 
information helps you track your progress over time.
To set user data:

1. Press   / KCAL to navigate to HR measurement 

mode.

2.  Press and hold to MODE to enter User Data mode.
3. Press SET to change values of the setting.
4. Press MODE to confirm.

The setting sequence is as follows: set Lower limit; set 
Upper limit; set Age; set Weight unit; set Weight.

 You must enter your user data to enable the calorie 

count function.

•  Press 

 / KCAL to navigate to HR mode.

•  Press 

 / KCAL to view calories burnt.

 The calorie display will only appear for 

approximately 3 seconds.

The SE122 uses a CR2032 lithium battery for the transmitter 
and a CR2032 for the receiver. Both are included with the 
unit. When the receiver battery is running low, the low 
battery indicator 

 will light up on the watch display.