Справочник Пользователя для Mitsubishi Electronics -NZ2GF2B-60DA4

77

CHAPTER 8 FUNCTION

8.1  Mod

e Shift at

 P

o

wer-

on

  

This chapter describes the details of the functions available in the D/A converter module, and the setting procedures 
for those functions.
For details on remote I/O signals, remote registers, and remote buffer memory, refer to the following.

 • Details of Remote I/O Signals (

 • Details of Remote Register Areas (

 Page 158, Appendix 2)

 • Details of Remote Buffer Memory Areas (

At power-on, the mode of the D/A converter module shifts to any of the following.

 • Offset/gain setting mode
 • Unit test mode
 • Normal mode
 • Trigger output mode
 • Synchronous communication mode

The following table lists conditions where the mode shifts.

a)

Offset/gain setting mode

If "X10" of the station number setting switch is set to "O/G", the mode shifts to the offset/gain 
setting mode.
For details, refer to the following.

• Offset/Gain Setting (

b)

Unit test mode

If "X10" of the station number setting switch is set to "TEST" and "X1" of the switch is set to "0", the 
mode shifts to the unit test mode.
For details, refer to the following.

• Unit test (

Page 148, Section 11.5)

c)

(Drive mode switch)

If the station number setting switch is set to 1 to 120, the mode shifts according to the setting of 
Mode switch (address: 0000

H

).

For details, refer to the following.

• Drive Mode Switch (

c)

b)

a)

Unit test mode

Offset/gain setting mode

Trigger output mode

Power-on

(Drive mode switch)

Normal mode

Synchronous

communication mode