Справочник Пользователя для Pelco ICIMI1000
Pelco Manual C1014M-B (10/97)
7
3.2.4 Procedures for the Suntronics Station Minder 890,
960, and 2000 Cash Registers
The following procedures are to be performed on the Suntronics Station Minder
890, 960, and 2000 Cash Registers
890, 960, and 2000 Cash Registers
1.
Be sure the cables on the wiring kit are connected to the yellow and black
terminals only.
terminals only.
2.
If the communication parameters settings in the Inter-Check
®
Programming
section do not work correctly, check the switch settings underneath the printer
to determine printer communication settings and adjust the Inter-Check
to determine printer communication settings and adjust the Inter-Check
®
pro-
gramming to match the new printer settings.
Also, printer communication settings can be determined by proceeding with
one of following methods:
one of following methods:
a.
Turn the printer “off”. Press the printer “line feed” and “form feed” buttons
at the same time while you turn the printer “on”. Continue to hold the
buttons down as the printer prints the proper communication settings on
a receipt.
at the same time while you turn the printer “on”. Continue to hold the
buttons down as the printer prints the proper communication settings on
a receipt.
b.
Turn the printer “off”. Press either the printer “line feed” or “form feed”
button while you turn the printer “on”. Continue to hold the button down
as the printer prints the proper communication settings on a receipt.
button while you turn the printer “on”. Continue to hold the button down
as the printer prints the proper communication settings on a receipt.
3.
Set the SW1 switch on the ICIMI1000 interface cable toward the male plug.
3.2.5 Procedures for the Verifone Ruby Super System
Cash Registers
The following procedures are to be performed on the Verifone Ruby Super System
Cash Registers
Cash Registers
1.
Configure the PIM default before setting up communication parameters by
programming the following:
programming the following:
a.
Press “ENT” on the keypad to enter programming mode.
b.
Press “6” for Diagnostics.
c.
Press “8” for (DL) PIM Default Load.
d.
Press “ESC” to exit programming mode.
2. Configure the communication parameters by programming the following:
a.
Press “ENT” on the keypad to enter programming mode.
b.
Press “1” for Channel 1 Setup.
c.
Press “2” for Data Format/Communication Protocol.
d.
Press “ENT” or the up and down arrow cursor control keys to scroll through
your protocol options. The selection you use will show “Selected: RS232
Standard Printer” on the monitor.
your protocol options. The selection you use will show “Selected: RS232
Standard Printer” on the monitor.
e.
Press “ESC” three (3) times to save the selection and return to monitor-
ing mode.
ing mode.
3.
Be sure the cables on the wiring kit are connected to the yellow and black
terminals only.
terminals only.
4.
The ICIMI1000 interface cable must be plugged into the printer rather than
the register in order for this interface to operate.
the register in order for this interface to operate.