Справочник Пользователя для Hotpoint ACC9 BF7

The On/Off button/ light  , if the dryer is running and this 

button is pressed and held for more than 3 seconds the dryer 

is turned off. The light signals that your dryer is in use or ready 

to select a programme.
The Programmes knob sets the programme: rotate until the 

indicator is pointing to the programme you want to select (see 

Start and Programmes).
The  Option  buttons/ lights select available options for your 

selected programme. The lights indicate that the option has 
been selected (see Start and Programmes).
The Display Panel has three sections: Sensor Dry = Drying 

level, Timed dry = Drying time and Time to End / Delay start 

each with a corresponding selection button (see The Display). 

START/PAUSE button with indicator light  : when the 

green indicator light flashes slowly, press the button to 

start the programme. When the cycle has started, the 

indicator light is illuminated in a fixed manner. To pause the 

programme, press the button again; the indicator light will 

turn orange and begin to flash again.

To restart the programme from the point at which it 

was interrupted, press the button again (see Start and 

Programmes).
The  Programme Progress Lights indicate each state of 

the programme by turning on as appropriate (see Start and 

The Empty Water indicator 

“h2o”

 signals that the water 

container should be emptied. The light will take a few seconds 

to go out after replacing the empty water container; the dryer 

must be running for this to happen (see The Controls). 

Note: if the water bottle is full the display shows 

“h2o”

 and the 

 indicator flashes, the heat is turned off and your clothes will 

not dry. 
The Empty Water / Clean Filter Light   gives a reminder 

before every programme, that its essential to clean the filter and 

empty the water container every time the dryer is used (see 

Maintenance and Care).
The Clean Condenser Light 

 gives a reminder, that its 

essential to clean the condenser at regular intervals (see 

Maintenance and Care).
The Child Lock button/light 

 Press and hold this button after 

selecting your programme and any options. This prevents the 

programme settings from being changed. 

When the light is lit the other buttons and programme knob are 

disabled. Hold the button to cancel and the light will go out.
ECO Light - this light is illuminated as you select options that 

use less energy (see the controls).

Pull on handle

Condenser unit 

(cover open)

 

Water 

container

 

Rating 

Plate

 

Condenser 

cover handle 

(Pull to open)

 

Filter

 

Air Intake 

Grille

 

Model 

& Serial 

Numbers

 

Option Buttons and Lights

On/Off Button & Light

Display Panel

Child Lock 

Button & Light

Start/Pause  

Button & Light

Clean 

Condenser 

Light

 Programme 

Progress Light

Programme Knob

Empty 

Water /

Clean Filter 

Light

ECO  

Light

Sensor Dry

Timed Dry

Delay  

Timer